How to set up and connect the wireless diagnosis of the Porsche Piwis3 diagnosis software

How to set up and connect the wireless diagnosis of the Porsche Piwis3 diagnosis software

1.Introduction to VCI communication module;

(1) Vehicle communication module VCI；
(2) Aviation interface line of PIWIS detector；
(3) WLAN cap；
(4) docking station (or VCI base station)；
(5) Dual-head USB cable for connecting the VCI base station to the Y-shaped USB cable of the PIWIS detector；
2.Computer connection VCI;

Tip: The dual connector USB cable is connected to the computer, and the single connector USB cable is connected to the docking station until a horizontal line is displayed below the VCI connection status in the lower left corner of the Porsche system. The connection is successful.

Click on VCI configuration

3.Click “Home” – “VCI Configuration”, enter the VCI configuration interface, enter the general menu and click “Perform pairing now”
Pairing is matched. If the matching VCI diagnostic connector is grayed out, do not rematch and continue to the next step.
It should be noted that if clicking “Perform pairing now” is unsuccessful, the wireless hat on the VCI needs to be taken down.
Newly enter the VCI configuration, click “Reset VCI to factory settings” to continue matching.

4.Select “WLAN access point”, set the wireless password of the VCI connector, the network name cannot be changed, and the number of the network name is followed.
The word is the SN (PT3G_VCI_5159003), the network security key can be set by itself, and the password can exceed eight digits.
The channel can be set by itself. The password set by me here is 12345678, and the channel is 11, which will activate the WLAN access after startup.
Ask the mode”, then click “Use in VCI”, the cue point is normal, and the wireless setting is completed.

5.When the setup is complete, click on “Home” -”network configuration”-”setting s”,
Choose “discard WLAN”，Disconnect other network connections

7.Click Update until you find the PT3G_VCI_XXX wireless network，click Update until you find the PT3G_VCI_XXX wireless network, select PT3G_VCI_XXX, click save, the password is the password you set 12345678. If it is not saved successfully, you can click save again.

8.When the connection status of PT3G_VCI_XXX is displayed in the lower left corner of the computer screen, the connection is successful. If Error: PPN status is prompted, please ignore it. PPN is the Porsche dealer network.